Two-Platen Plastic Injection Molding Machine CHG25J
  • Two-Platen Plastic Injection Molding Machine CHG25J

Two-Platen Plastic Injection Molding Machine CHG25J

Production country: China

Cost in place: Moscow

Выберите город:

Цена по запросу

Min. order qty 1 pcs

Основные характеристики

  • Brand

    CHAP

  • Modification

    Fully hydraulic injection molding machines

  • Processing plastics

    ABS resin, LDPE resin, HDPE resin, Polypropylene (PP)

  • Screw diameter

    22 mm

  • Screw diameter

    25 mm

  • Screw diameter

    28 mm

  • Clamping force

    250 kN

  • Max. mould height

    430 mm

Similar goods

Описание:

Hydraulic Two-Platen Plastic Injection Molding Machine HG25J

  • CHAP hydraulic two-platen plastic injection molding machine is energy efficient, which uses 45%-80% less energy than traditional injection molding equipment. 
  • It uses Siemens control panel (specially designed for injection molding machine) to monitor the whole process and display fault diagnosis timely. 
  • It runs smoothly and causes low noise. 
  • The permanent magnet AC servo motor can reach the maximum output within 0.1 second.
  • Full closed-loop control.

General properties

  • Modification: Fully hydraulic injection molding machines
  • Processing plastics: ABS resin, LDPE resin, HDPE resin, Polypropylene (PP)
  • Heating power: 3.8 kW

Injection unit

  • Number of Injection zones: One injection zone pcs
  • Screw : A
  • Screw diameter: 22 mm
  • Theoretical Injection Capacity: 38 cm3
  • Injection Weight: 35 g
  • Injection Pressure: 358 MPa
  • Plasticizing Capacity: 6.1 g/sec.
  • Screw: A
  • Screw diameter: 25 mm
  • Screw L/D ratio: 22
  • Theoretical Injection Capacity: 49 cm3
  • Injection Pressure: 227 MPa
  • Injection Weight: 45 g
  • Plasticizing Capacity: 7.5 g/sec.
  • Screw: A
  • Screw diameter: 28 mm
  • Screw L/D ratio: 19.6
  • Theoretical Injection Capacity: 62 cm3
  • Injection Weight: 56 g
  • Injection Pressure: 221 MPa
  • Plasticizing Capacity: 8.52 g/sec.
  • Screw: A

Clamping unit

  • Clamping unit: Two-Platen Clamping unit
  • Clamping force: 250 kN
  • Max. mould height: 430 mm
  • Min. mould height: 150 mm
  • Space between Tie-Bars : 280×280 mm
  • Number of ejectors: 1 pcs
  • Ejector force: 25 kN
  • Ejector stroke: 60 mm

Pump

  • Pump pressure: 25 MPa
  • Oil tank capacity: 150 L
  • Double pump: -
  • Variable Pump: -

Additional

  • Rotary table: -

Power Supply

  • Motor power: 11 kW
  • Voltage: 380 V
  • Phase: Three-phase

Overall dimensions

  • Overall length: 2992 mm
  • Overall width: 1195 mm
  • Overall height: 1567 mm
  • Weight: 1800 Kg

Нет комплектующих товаров

Нет сопутствующих товаров